For the sake of the health of my plants and the sake my own hobby ventures I got particularly interested at somewhat elevated CO2 levels. The
airtight-hood-CO2-controller-test-tank It have gave exceptionally more healthy plant growth at 5-10
ppm. So for my display tank I shut down the aeration and did a couple of days without to compare CO2 levels every 15 minutes of the day. I can give you the entire analysis (aggregated graphs are attached), but this is the outcome:
When aerating a tank, the difference in CO2 (ppm) between the a digital drop checker and the ambient air is smaller than the tank isn't aerated at all.
The simple explenation would be that heavy aeration forces maximum diffusion between the tank water and the ambient air, therefore the difference in CO2 level will decrease. So my tank could have had the highest achievable CO2 level when not aerating at 02:00 AM so benefitting from CO2 production and only start the air pumps roughly 02:00 hours when CO2 level dropped below ambient.
But after running CO2 levels between 1.2 and 1.9 ppm for 2 years now, it time for elevated levels! My initial target is to run it at 5 ppm. I do know some of you might think "well that still very low?!" but currently I want better health for my current plant species selection, and upgrading from an average 1.5 to 5 ppm would be huge. So I hooked on a CO2 bottle, printed a mount for a beaker et voila: an old skool CO2 bell reactor...

No need for tech, just keep it simple.
So after running it for almost 48 hours, I came to the conclusion the bell isn't big enough surface wise:

(This is a graph not from my data analysis tool, but I (AI assisted I must confess) gave my digital drop checker some graphing functionality on its own.)
The peak at the end of the dark period is 2000 ppm, an equivalent of 3 mg/l in water. So the CO2 level has increased 100%, but the bell need an upgrade.
So currently I'm printing a bigger and rectangled version without the beaker, customized with purge notch and tubing insert.
Cheers!
EDIT: Oh and for some who notices the instability/peaks: CO2 creeps up at night which I will mitigate by shut off the solenoid every hour at night, and the lows should be tackled by increasing the CO2 diffusion (CO2 reactor bell surface) and assumed to be on par with CO2 uptake.