Hi al;,
I have been growing plants such as ludwigia palustris green, ludwigia palustris atlantis and limnophila aromatica green in my 90P for some time now, but I keep noticing that the lower leaves are being attacked by (I believe) staghorn algea. The new growth looks good (freshly green without twists) but then after ~1 week after the plants growths slowly twist and get attacked by algea. Over the past months, I have (step-by-step) adjusted the lights, CO2, ratio of Ca/Mg, macro (Nitrate) levels but nothing seems to help.
Aquarium 90P:
I was already a bit lost on my 90p, as I feel the parameters and routine are good. Also, I have been trying not to tweak to many parameters and keep the tank stable, but the issue still remains.
About two weeks ago, I bought some ludwigia palustris green for my 20L shrimp tank. This tank tank used the same level of Co2, Ca/Mg, also apt feast but in this tank I use a lean dosing method (Nitrate fluctuate between 0-5ppm). Also use way more lights as the tank is pretty stable.
To my surprise: the leaves of the 'lower' ludwigia palustris green are also curling in the 20L tank!
I might want to get some advise on the staghorn on my 90P tank later, but I want to start on the curling leaves issue that I have in both tanks.
Because the (water dosing) fertilizers are so different between the tank, i feel it can't be that. Also the CO2 is stable and flow is good..
Does anyone know what causes this and how this can be solved?
(photos 1-3 are of the 90p tank, photos 4 - 8 are from the 20L tank. Just did a bigger trimming on both of them, so tanks don't look at their best atm.)
I have been growing plants such as ludwigia palustris green, ludwigia palustris atlantis and limnophila aromatica green in my 90P for some time now, but I keep noticing that the lower leaves are being attacked by (I believe) staghorn algea. The new growth looks good (freshly green without twists) but then after ~1 week after the plants growths slowly twist and get attacked by algea. Over the past months, I have (step-by-step) adjusted the lights, CO2, ratio of Ca/Mg, macro (Nitrate) levels but nothing seems to help.
Aquarium 90P:
- My light is Chihiros WRGBII 90 Cm at 40% (~60 PAR, measured with Photone app). I lowered it because the tank feels unstable and suffers from persistent staghorn algea
- CO2 is ~30ppm or heigher (1.7 Ph drop) with plenty of surface agitation and skimmer inlet. Drop checker is lime green or even slightly yellow-ish 1 hour after lights come on
- KH 0 and GH 6 (Ca:Mg, 4:1), because of shrimp. Use Magnesium Sulfate Hepta and Calcium Sulfate Di. Ca: 30ppm and Mg: 7.6ppm
- EI dosing. Weekly NPK = 22 NO3, 6 PO4, K 24 ppm. 50% front load (as 50% water change) and the other 50% split into daily doses.
- Measured NO3 before water change: ~20ppm.
- Burr Micro mix recipe with total Fe 0.45 ppm weekly, daily dosing (Fe EDTPA and gluconate)
- APT Feast (6 months old)
- Oase Biomaster Thermo 850. Mature filter (no filter floss, no purigen or other additives). Extra mini booster pump to create theoretical 'light whirlpool' effect with the lily pipe outlet. Clean prefilter every week, leave main filter and only clean 4-6 months.
- Always do 50% water change and lightly siphon aqua soil without disturbing deeper layers every week.
I was already a bit lost on my 90p, as I feel the parameters and routine are good. Also, I have been trying not to tweak to many parameters and keep the tank stable, but the issue still remains.
About two weeks ago, I bought some ludwigia palustris green for my 20L shrimp tank. This tank tank used the same level of Co2, Ca/Mg, also apt feast but in this tank I use a lean dosing method (Nitrate fluctuate between 0-5ppm). Also use way more lights as the tank is pretty stable.
To my surprise: the leaves of the 'lower' ludwigia palustris green are also curling in the 20L tank!
I might want to get some advise on the staghorn on my 90P tank later, but I want to start on the curling leaves issue that I have in both tanks.
Because the (water dosing) fertilizers are so different between the tank, i feel it can't be that. Also the CO2 is stable and flow is good..
Does anyone know what causes this and how this can be solved?
(photos 1-3 are of the 90p tank, photos 4 - 8 are from the 20L tank. Just did a bigger trimming on both of them, so tanks don't look at their best atm.)
Attachments
-
PXL_20261120_130627771.webp114.2 KB · Views: 10 -
PXL_20261120_125422437.webp92.9 KB · Views: 9 -
PXL_20261120_114203475.webp97.7 KB · Views: 9 -
PXL_20261120_125500102.webp72.7 KB · Views: 9 -
PXL_20261120_125506345.webp74.5 KB · Views: 9 -
PXL_20261120_114330660.webp184.8 KB · Views: 9 -
PXL_20261120_114341108.webp108.5 KB · Views: 9 -
PXL_20261120_135238188.webp282.1 KB · Views: 8
Last edited: