This is my first time using a reactor. I have a Landen 100p (40x18x18 inches) and just received my Aqua Rocks Colorado Stainless Yugang Reactor . I had a spare Eheim 4+ 350 so it's now hooked to that with just foam filtration. My other filter is an Oase Biomaster Thermo 600 with an 850 head. I'm a little confused on the initial setup. I have my Co2 turning on at 9:30am, lights on 12-8pm. I have the offsets at 50% of the reactor, and the surface area is 4 inches larger than the calculations said I needed.
I know that contact time is the factor so my Eheim is about 50% flow. Do I initially increase the Co2 rate to purge the air out of the reactor, then dial it back so i'm seeing off-gassing every minute once I'm reaching my ppm? I'm using a Co2 Art Elite Pro regulator. My psi sits between 35-40 on a 20lb tank. Co2 is easy for me to get and cheap so I'm not concerned with excess. There's not a lot of information I can find on these so anything helps. Thanks for reading!
I know that contact time is the factor so my Eheim is about 50% flow. Do I initially increase the Co2 rate to purge the air out of the reactor, then dial it back so i'm seeing off-gassing every minute once I'm reaching my ppm? I'm using a Co2 Art Elite Pro regulator. My psi sits between 35-40 on a 20lb tank. Co2 is easy for me to get and cheap so I'm not concerned with excess. There's not a lot of information I can find on these so anything helps. Thanks for reading!
